Attention to use of plate shears

- Apr 04, 2020-

1. Start the plate shearing machine to idle for several cycles to ensure that under normal conditions, try to cut different thickness of plate from thin to thick. Make sure that the user is familiar with the performance of the shearing machine.

2. The clearance of different blades must be adjusted when the thickness of plates is different. If the corresponding blade clearance is not adjusted, the blade durability will be affected.

3. Open the pressure gauge switch during the shearing process of the plate shearer, observe the pressure value of the oil circuit, and the pressure shall be less than 20MPa when shearing 12mm plates. The remote pressure regulating valve No9 is set at 20-22mpa when leaving the factory. The user must abide by this regulation. It is not allowed to increase the pressure for cutting the material surface beyond the specified value, causing damage to the machine.

4. Sound balance during operation. If there is noise in the plate shearer, stop the machine for inspection.

5. When the plate shearer is operated, the temperature of the oil tank shall be increased by less than 60 degrees, and when it is over, it shall be shut down for rest.