Fault: continuous steel strip cutting
Cause: 1) cutter wear or failure
Maintenance method: check whether the cutter or cutter holder is worn or faulty. If it is worn seriously, replace it
2) Reduced air pressure
Maintenance method: check whether the working pressure is normal;
Cut off the steel belt force from the locking cylinder. Refer to the fault phenomenon;
Check blocking operation
Fault: insufficient tension on the latch clamp
Cause: the connecting hole or pin of the clamp block is worn
Repair method: check these parts when the groove depth is shallow, and replace them if necessary
Scrap copper packer is a good helper for scrap copper packing.