The processing method of the non-return tape of the Automatic Scrap Metal Baler

- Jul 10, 2020-

It is very important that the automatic packing machine does not return the tape, which is related to the normal operation of the packing machine. Sometimes a small problem will cause the automatic baler to fail to take back normally.

The reasons and repair methods of the non-returning belt of the automatic baler mainly include the following methods:

1. Induction switch 1S-2 contact time is not correct, just adjust the time;

2. The belt of the motor M2 is damaged or the belt pulley is loosely fixed, and the belt or pulley can be replaced (sometimes it is very likely due to the long time of the machine and the belt aging);

3. Check whether the unloading force is too small, if it is too small, the lever tension spring can be adjusted downward properly.

When the automatic baler can not be returned normally, the baler can no longer be consciously and forcefully used, and the maintenance should be stopped. At the same time, we must pay attention to the maintenance of the machine in the normal process of machine operation.

https://www.acesunbaler.com