Common Faults Of Steel Chips Briquetting Press

- Feb 12, 2021-

Many customers will fail when they use the metal briquetting machine for a long time. What should I do at this time? In fact, there are two common failures: incorrectly worn straps. Open the right door on the front of the metal briquetting machine (the panel is the front of the machine), and thread the belt correctly in accordance with the "threading process method" indicated on the fifth page of the manual or the drawing diagram of the inner right door. There are foreign objects in the upper and lower extensions. The metal briquetting machine has been used for a long time without timely cleaning and maintenance, resulting in the accumulation of stolen goods in the machine (the packing belt is too wide, and there is also a roll of packing tape with multiple joints), which makes the delivery of the belt not smooth You should do more cleaning and maintenance. The electromagnet is not working properly. The solenoid does not work. First check whether the welding head of the solenoid connection is off, and then check whether the coil is burned out. If neither is abnormal, check whether the electromagnet is displaced or blocked by stolen goods, so that the bullet cannot move freely. Supplement: (The connection of magnetron and circuit board should also be checked) The metal briquetting machine does not automatically cut tape. There is oil on the slip sheet or the tightened drive belt. Remove the slip sheet to remove the oil, wipe it dry and then assemble it in order. The drive belt is too loose. Adjust the transmission frame seat (Tigong) downward or adjust the motor backward to tighten the belt. The thickness of the PP packaging tape is too thin or the gap between the unwinding rollers is too large. The gap between the unwinding rollers should be only 0.05-0.1mm larger than the thickness of the belt, and adjust according to this requirement. The magnetron (cut tape sensor) is faulty, and the magnet is off or damaged. The balance position of the crossbar is not adjusted properly.

https://www.acesunbaler.com