Should Pay Attention To When Cleaning Non-metal Balers

- Nov 08, 2019-

Should pay attention to when cleaning non-metal balers

The cleaning of the hydraulic system inside the non-metallic baler is very effective for the baler, as a non-metallic baler requires a good hydraulic system. Therefore, in the daily work, the cleaning work of the baler should not be underestimated, and must be taken seriously. under

Face, let's take a look at the precautions for cleaning non-metallic balers:

First use a special low-viscosity cleaning oil. When cleaning, add the oil to the tank of the straw baler and heat it to 50-80 degrees Celsius. Start the hydraulic pump and let it run empty. Always wipe the tube gently when cleaning, the purpose of doing this

It is the effect of removing the attachments, cleaning the oil filter for 20 minutes, cleaning the filter, and then cleaning, and repeating until the filter does not have many contaminants. Non-metallic baler cleaning

It is usually 2 hours. For a messy hydraulic system, each zone can be cleaned separately according to the work area. It can also be connected to a hydraulic cylinder to reciprocate the hydraulic cylinder for system cleaning.

After cleaning, the cleaning oil must be drained as much as possible to clean the inside of the tank. Then remove the temporary cleaning circuit to return the non-metallic baler system to normal operation and add the specified hydraulic oil.